裝載機制動器活塞卡死怎么辦？
[ 發布日期：2023-01-07 15:10:28 ] 來源:永保機械 瀏覽：862次
裝載機鉗盤式制動器是裝載機配件的一種，其防污能力差，活塞常因銹蝕或太臟而卡死。
Shandong loaders caliper disc brake is a loader accessories, and its anti-fouling ability, often due to corroded or dirty piston and stuck.
裝載機活塞卡死不是很嚴重時，可以用撬棍橇出，或用錘子敲打制動器背面使其靠慣性振出；卡死過緊時，可在制動器正對活塞中心的背面鉆一個8mm的通孔，然后用沖子或螺栓伸入孔中用錘子敲打，就很容易將活塞取出。修復或更換后，再用M10的絲錐在孔內攻絲，然后用M10乘10的螺栓及銅墊片堵住此孔。
Shandong loaders live Fonseca died not very serious, you can ski out with a crowbar, or with a hammer on the back of it by inertia brake vibration out; when stuck tight, in the center of the brake piston is on the back of an 8mm drill through hole, and then inserted into the hole punch or bolt with a hammer, it is easy to remove the piston. Repair or replacement, and then tap in the hole tapping M10, M10 and then multiply by 10 bolts and copper gaskets block this
hole.
