裝載機在工作過程中，如果機油的壓力低于0.2 MPa應立即停機查找原因，待排除故障后方可繼續工作，否則會釀成燒瓦、拉缸等重大機械事故。下面商河永保機械的專家給大家介紹一下山東裝載機機油壓力的影響因素有哪些？

1、若裝載機機油油量不足，會使機油泵的泵油量減少，導致機油壓力下降，加劇曲軸與軸承、缸套與活塞的磨損；若山東裝載機發動機溫度過高，不但加速機油老化、變質，也容易使機油變稀，導致油壓下降。
If Shandong loaders oil fuel shortage, it will reduce the oil pump fuel pump, causing oil pressure drop, increasing the crankshaft and bearings, cylinder and piston wear; if Shandong loader engine temperature is too high, not only to accelerate the aging of oil, bad, but also easy to oil thinning, resulting in decreased oil pressure.

2、裝載機機油泵的驅動齒輪與驅動軸的固定銷斷裂或配合鍵脫落，以及機油泵吸入異物而將泵油齒輪卡住，都會使機油泵停止運轉，機油壓力也隨之降為0。山東裝載機發動機長期使用后，曲軸與連桿軸承的配合間隙會逐漸增大，機油壓力也隨著下降。
Shandong loaders oil pump drive gear and drive shaft fixing pin breakage or loss with the key, and pump inhaled foreign body and will pump oil gear jammed, will cause the oil pump is stopped, the oil pressure also will be reduced to zero. Shandong loader engine after long-term use, with the gap crankshaft and connecting rod bearings will gradually increase, along with the oil pressure drop.

3、裝載機機油濾油器堵塞，當機油因?yàn)V油器堵塞而不能流通時，設在濾油器底座上的安全閥就被頂開，機油便不經過濾而直接進入主油道。如果安全閥的開啟壓力調得過高，濾油器被堵塞時，安全閥就不能及時打開，于是機油泵壓力升高，內漏增加，主油道供油量減少，引起油壓下降；若回油閥彈簧疲勞軟化或調整不當，閥座與鋼珠的配合面磨損或被臟物卡住而關閉不嚴時，回油量便明顯增加，主油道的油壓也會隨之下降。
Shandong loaders oil filter clogging, when the oil can not flow due to filter clogging, located at the base of the safety valve on the filter was the top open, the oil will not filtered directly into the main oil. If the safety valve opening pressure adjusted too high, when the oil filter is clogged, the valve can not be opened in time, so the pump pressure increases, leakage increases, reducing the amount of the main oil supply, causing oil pressure drop; if when the return valve spring fatigue softening or improperly adjusted, with the surface of the valve seat and ball worn or loose dirt stuck closed, the oil will return to a marked increase in the main oil hydraulic pressure will drop.

4、裝載機機油散熱器及管路漏油，會使油壓下降，管路若被臟物堵塞，也會因阻力增大而使油的流量減少、油壓下降。若山東裝載機油壓傳感器失靈，或由主油道至油壓傳感器的油管因污垢積聚而流通不暢時，油壓表將顯示機油壓力下降。
Shandong loaders oil radiator and piping oil spills, oil will fall, if they are clogged with dirt pipeline, also due to increased resistance to reduce the flow of oil leaving the oil pressure drop. If the oil pressure sensor failure Shandong loader, or by the main oil pipeline oil pressure sensor due to dirt accumulation and poor circulation, the oil pressure gauge will show oil pressure drop.

5、裝載機機油若過臟、過黏，就容易堵塞吸油盤，當發動機小油門低速運轉時，機油泵吸油量不大，主油道尚能建立起一定的壓力，油壓會正常；但當加大油門高速運轉時，機油泵的吸油量會因吸盤阻力過大而明顯減少，進而造成機油壓力表的顯示值下降。
Shandong loaders oil if too dirty, too sticky, it is easy to plug the suction plate, when the engine is small at low speed throttle, oil pump oil absorption is not, the main oil can still build some pressure, oil pressure is normal; but when the throttle at high speed, oil absorption due to the oil pump sucker too much resistance and significantly reduced, which causes the oil pressure gauge displays the value decline.