1、裝載機發動前要檢查發動機的油量,水量是否加足。并將各操作桿放在空檔位置,經檢查合格再發動機 器低速運轉,同時檢查各種儀表是否正常。
Front loader launched to check the engine oil, whether to add a little water. And each operation lever on the neutral position, and then pass through the check engine is running at low speed, while a variety of instruments to check whether it is normal.
2、 堅持例行保養,機械經常保持完好,機件失靈,必須檢修好,在機械運轉中,禁止進行清潔、緊固、潤滑、調整等各項工作。
Adhere to routine maintenance, mechanical keep intact, malfunction, must overhaul good mechanical operation, prohibited work cleaning, tightening, lubrication and adjustments.
3、 裝載機在開車前,注意檢查周?chē)欠裼姓系K物和危險物,對工作地段有影響施工的障礙物等必須事先清除后再進行工作,酒后禁止開車。
Loader before driving, pay attention to check whether there are obstacles and dangerous objects around, lots of influential work of construction obstacles must be cleared in advance before work, drunk driving is prohibited.
4、 操作機械時,司機必須精力集中,不準吸煙和與他人玩笑打鬧,身體有病(有醫生證明者),不要勉強操作,嚴禁非司機開車。
When operating machinery, drivers must concentrate, no smoking and slapstick jokes with others, physical illness (medical certificate), with not reluctantly operation, the driver drove strictly prohibited.
5、 裝載機在公路上行駛,要嚴格遵守交管部門頒發的有關交通規則、法令。中速行駛,安全禮讓,下坡時, 禁止空檔滑行。
Loader on the highway, the traffic control department to strictly abide by the traffic rules issued decrees. Moderate speed, safety comity, downhill, coasting in neutral prohibited.
6、 在土質堅硬情況下,裝載機不準強行推鏟,以免損壞機件,必須選用其它機械翻松后,再用裝載機工作。
In the case of hard soil, shovel loaders are not allowed to forcibly push to avoid damage to parts, other machinery must be selected after scarifying, then the loader work.
7、 嚴格執行保養規程,每次工作完要將機械擦拭干凈,檢查各部位緊固、潤滑、調整情況。
Strictly enforce the maintenance order, complete each job you want to wipe machinery clean, inspect all parts of the fastening, lubrication, adjustments.
8、 每工作200-250小時進行一次一級保養,檢查調整各部間隙,緊固各部軸承,更換機油。
200-250 hours per work once a maintenance check and adjust the gap ministries, ministries fastening bearings, replace the oil.
9、 每次工作下班時,應將機械開到安全地段,不準停在坑洼流水處,要做好運轉記錄,關閉門窗加鎖后, 司機方可離崗(冬季還應將機體和小箱內存水放凈,以防凍缸)。
Each time commuting to work, to a safe location should be mechanical, potholes are not allowed to stop at the water department, to do work record, close the doors and windows locked, the driver only undergo (winter should be the body and casket memory The net release of water to antifreeze tank).