山東小型裝載機如何更換變速油箱油？
[ 發布日期：2023-01-07 15:10:28 ] 來源:永保機械 瀏覽：715次
1、接油容器放在放油螺栓下，取下螺栓，并放油。為防止小型裝載機郵箱內油突然流出，松開螺塞，并逐漸取下螺栓。
Then placed in a container of oil under the oil drain plug, remove the bolts, and put the oil. To prevent a sudden outflow of small loaders mailbox oil, loosen the plug, and gradually remove the bolts.
2、放油后，裝在螺塞并擰緊。
After the release of oil, mounted on plug and tighten.
3、接油容器放在小裝載機變速箱濾油器下。
Then oil container on a small loader gearbox oil filter.
4、取下小裝載機變速箱濾油器放油螺塞，放油后擰緊螺塞。
Remove the small loader gearbox oil filter drain plug, and tighten the oil drain plug.
5、取下螺塞、蓋，并取出濾網。
Remove the plug, cover, and remove the filter.
6、清除粘在小裝載機濾網上的贓物，然后用柴油或清洗油清洗，如濾網損壞，更換。
Clear filter stuck on a small loader stolen goods, and diesel oil washing or cleaning, such as the filter is damaged, replace it.
7、裝配蓋上螺栓時，按住蓋，均勻緊固螺栓，重新安裝濾網。
Cover assembly bolts, hold down the lid, tighten the bolts evenly, reinstall filter.
8、經加油口注入一定數量的機油。
After a certain amount of filler injected into the oil.
9、檢查油位，并加油至規定油位，檢查濾油器蓋裝配處是否漏油。
Check the oil level and oil to the specified oil level, check for leaks at the oil filter cap assembly.
